Design and construction of bored cast-in-situ piles founded on rocks - Guidelines
1998 الطبعة

Based on IS 14593, Clause 6.5.1 and the associated Table 1, minimum socket lengths for rock-embedded piles vary according to the rock type and pile diameter (D):

Additional notes:

• The minimum socket length should not be less than twice the pile diameter (2 × D) as per Clause 6.8.2.2.
• These values should be validated through static analysis and preferably confirmed with load testing.
• Proper cleaning and construction techniques are critical to ensure the socket's integrity and performance.

جارٍ تحميل المخطط…

The ultimate load capacity of a rock-socketed pile, as outlined in IS 14593, is the sum of side shear resistance and end bearing resistance:

[ Q_u = Q_s + Q_b ]

Where:

• (Q_u) = Ultimate load capacity
• (Q_s = \tau \times A_s), the shaft resistance from side shear, with (\tau) as the shear strength at the interface and (A_s) as the socket surface area (circumference multiplied by socket length)
• (Q_b = \sigma_b \times A_b), the base resistance from end bearing, where (\sigma_b) is the bearing capacity of the rock at the pile base and (A_b) is the cross-sectional area of the pile base

Key factors affecting capacity include rock quality and strength, interface bonding efficiency, rock mass properties, and proper socket cleaning and construction.

جارٍ تحميل المخطط…

IS 14593 specifies the following procedures for cleaning the pile socket after boring and before concreting:

• Remove all rock fragments, soil, and loose material from the pile base.
• Recommended cleaning techniques include:
  • Rope-operated grabbing devices
  • Hydraulically driven grabs mounted on Kelly bars
  • Air-lift methods, particularly effective for rock debris removal
• Cleaning must occur immediately after reinforcement placement and before concreting (Clause 5.5).
• Concreting should proceed promptly and continuously after cleaning to ensure proper bonding.
• When permanent liners are employed, the base concrete is placed using the tremie method to seal against groundwater ingress (Clause 5.6).

These steps are critical to establish a clean interface for effective load transfer between the pile concrete and rock socket. For additional details on workmanship and materials, IS 2911 (Part 1/Sec 2) should be consulted.

جارٍ تحميل المخطط…

Per IS 14593 Clause 6.8.1, uplift resistance in bored cast-in-situ piles anchored in rock is primarily achieved through the development of adequate sidewall shear resistance within the rock socket. Although enlarging or bell-shaped pile bases can provide uplift resistance, such methods are generally impractical and uneconomical in rock due to construction difficulty and expense.

More cost-effective and reliable is increasing the depth of the rock socket to enhance side shear capacity. Design must ensure that the pile shaft can safely withstand uplift, compression, and bending moments (Clause 6.1), and that loads are transferred without causing rock failure or excessive settlement.

Summary:

This strategy capitalizes on the high shear strength of rock sockets to resist uplift forces effectively.

IS 14593 outlines load testing and acceptance criteria as follows:

• Design intent (Clause 6.1) requires piles to transfer loads to rock without triggering rock failure or excessive settlement that could harm the structure.
• Load transfer mechanisms include side shear along the concrete-rock interface and end bearing at the pile tip.
• Minimum socket lengths (Table 1, Clause 6.5.1) vary by rock type:

• Load testing should confirm the assumptions about load transfer and rock strength.
• Test load is generally 1.5 times the design load or as specified by the project.
• Monitor settlement during testing; acceptable settlement limits are usually less than 12 mm or as per project requirements.
• Load-settlement curves should demonstrate stable behavior without abrupt displacement.

جارٍ تحميل المخطط…